Blackbutt NSW
Blackbutt is an amazing timber that is hard and durable. It is a classic timber floor. It is light in appearance and suits modern homes. Blackbutt is supplied from two locations, firstly from the southwest of Western Australia and secondly, from the eastern states including New South Wales and Queensland. Blackbutt is a lovely timber to work with and is supplied in good lengths.
The eastern states variety often shows less grain and picks up slightly salmon colours.
Sanding/Installation comments.
Blackbutt sands well and is often installed using SIKA T. 55 directly onto concrete or on to plywood. [Always use a genuine sealer to seal the concrete slab when installing timber.] The sanding process is important as the timber usually needs to be burnished slightly before coating with waterborne finishes. Care should be taken not to miss any sanding grits during the sanding process, and be aware that rotary marks are often difficult to see. Use a good quality consistent abrasive. Care should be taken with the choice of finish. Most solvent based finishes adhere well to Blackbutt. Waterborne finishes are also often used on Blackbutt however it is extremely important not to work too far ahead of the main application area when coating the edges. New applicators can often be caught out in this area. VCS can recommend qualified floor sanders that can get the best out of this timber.
Suggestions ASK ABOUT OUR EXCELLENT 85 x 14 Heritage Grade NSW Blackbutt
Blackbutt is excellent with the OSMO range of oil finishes which highlight to grain while providing excellent protection.
vcs floorworks PERTH everything for flooring 